Installation; Site - Pkm KG162.4A+ Bedienungsanleitung

3. Installation

3.1 Site

1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection (adhesive tape) of the accessories.
Be very careful and do not use any aggressive or abrasive detergents to remove
residuals of the transport-protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Check that the appliance and the power cord are not damaged.
5. Install the appliance in a dry and well-ventilated place.
6. Protect the appliance from direct sunlight.
7. The doors must open completely and without hindrance.
8. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
9. Connect the appliance to the mains properly.
10. The nameplate is situated inside the appliance or at the back.
3.2 Installation
 Leave at least a free space of 5.0 cm above the appliance. If this cannot be
achieved, ensure that at least a free space of 2.5 cm is maintained on each side
of the appliance.
 If the appliance is positioned beside another fridge or freezer, leave at least a
free space of 2.0 cm between the appliances in order to avoid condensation.
 Attach the wall spacers to the condenser on the rear of the appliance. This will
ensure, that there is adequate ventilation space between the wall and the
appliance.
28