Parkside Performance PSSAP 20-Li E6 Originalbetriebsanleitung Seite 52

GB
MT
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
Dispose of batteries in an
environmentally friendly manner
Do not throw batteries into domestic
waste, fire (risk of explosion) or wa-
ter. Damaged batteries can harm the
environment and your health if pois-
onous fumes or liquids escape.
You are obliged to dispose of defective or
used batteries in an environmentally friendly
manner.
• Do not open the batteries and avoid
mechanical damage. There is a risk of a
short circuit and vapours may leak out,
causing irritation to the respiratory tract.
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Poor sawing performance
Saw blade quickly becomes
blunt
52
• For safety reasons, batteries should be
discharged before disposal.
• Tape the poles to prevent short circuits.
• Dispose of rechargeable batteries via a
retailer or collection point.
• Damaged batteries
Handle externally damaged batteries with
particular care!
• Do not touch damaged batteries with
• If you cannot tape the poles, place the
• Place damaged batteries individually
• Take damaged batteries to a collection
Possible cause
Rechargeable battery (9) not
inserted
On/Off switch (5) is broken
Defective motor
Rechargeable battery (9) dis-
charged
Internal loose contact
On/Off switch (5) is broken
Saw blade (15, 16) unsuitable
for the workpiece to be pro-
cessed
Saw blade (15, 16) blunt
Incorrect sawing speed
Low battery power
Saw blade (15, 16) unsuitable
for the workpiece to be pro-
cessed
Too much pressure applied
Sawing speed too high
your bare hands.
batteries individually in a plastic bag.
in a non-flammable, sealable container
that can still be filled with sand.
point with specialised personnel.
Error correction
Inserting the battery, p. 50
Contact the service centre.
Contact the service centre.
Charge the battery (see the
separate operating instructions
for the rechargeable battery
and charger)
Contact the service centre.
Contact the service centre.
Use a suitable saw blade (15,
16)
Use a new saw blade (15, 16)
Adjust sawing speed
Charge the battery (see the
separate operating instructions
for the rechargeable battery
and charger)
Use a suitable saw blade (15,
16)
Reduce the pressure
Reduce the sawing speed