Parkside Performance PSSAP 20-Li E6 Originalbetriebsanleitung Seite 51

2. Hold the device by the handle (7) and the
auxiliary handle (4) (insulated gripping
surfaces).
3. Press the switch lock (6).
4. Press and hold the On/off switch (5).
The LED work light (3) lights up.
5. Release the switch lock (6).
6. Wait until the device has reached its full
stroke rate.
Switching off
1. To turn it off, release the on/off switch (5).
The LED work light goes out after approx.
10 seconds.
2. Do not pull the sawblade out of the cut
until it has come to a standstill.
3. Remove the rechargeable battery (9) from
the device if you are leaving the device
unattended or if you have finished work-
ing.
Transport
Notes
• Turn off the device.
• Make sure that all moving parts have
come to a complete stop.
• Remove the rechargeable battery.
• Remove the attachment tool.
• Always carry the device by the handle (7).
Cleaning, maintenance and
storage
WARNING! Risk of injury due to unin-
tentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the battery
(9).
You should have any repair and maintenance
work that is not described in these instruc-
tions carried out by our Service Centre. Only
use original replacement parts.
Cleaning
WARNING! Electric shock! Never spray
down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents or
solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use a
damp cloth or brush to do this.
Maintenance
The device is maintenance free.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• In the case provided (17)
• out of the reach of children
Devices with battery:
• The storage temperature for the bat-
tery and device is between 15 °C and
25 °C. Avoid extreme cold or heat during
storage to ensure the battery output is
not adversely affected.
• Remove the battery from the device be-
fore storage over a longer period (see
separate operating instructions for battery
and charger).
Disposal/environmental
protection
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner.
Waste electrical and electronic
equipment (WEEE) must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at the
end of its useful life.
Directive 2012/19/EU on waste electrical
and electronic equipment:
Consumers are legally obliged to recycle
electrical and electronic equipment in an en-
vironmentally sound manner at the end of its
life. In this way, environmentally friendly and
resource-saving recycling is ensured.
Depending on the implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an official collection point,
• Return to the manufacturer/distributor.
GB
MT
51