Adjustment For Patient After Amputation In The Lower Limbs Area - Timago Stable-Tim Benutzerhandbuch

• In order to apply emergency braking or stopping lock, squeeze the lever of
the brake, and in order to release the brake, drop the levers. Perform this
ac�vity smoothly and with appropriate force.
Note! These brakes should not be used to slow down the wheelchair. If they are
o�en used for this purpose, they may cause tyre abrasion which will not be
covered by guarantee terms.
ADJUSTMENT OF BACKREST (GAS SPRING)
Smooth adjustment, up to horizontal posi�on, is performed by means of levers
located above the hand grips on the back of the backrest.
DETACH FUNCTION OF ARMRESTS
• To dismantle the armrest, twist off the (moun�ng) knob of the lock located
at the front part of the armrest and li� the armrest upwards.
• To re-assemble the armrest, put the armrest into the moun�ng openings
and �ghten the locking knob.
PUMPING THE WHEELS
• The wheelchair was equipped with pneuma�c rear wheels 24'' in diameter
and swivel, PU front wheels 8'' in diameter (tubeless tyre). Remember to
control the air pressure in both wheels and check the condi�on of the tyres
in search of abrasion, cuts or surface deple�on.
• To balance the air pressure in the wheels, twist off the cap of the valve,
insert the pump (included in the set) into the valve, and pump the air.

ADJUSTMENT FOR PATIENT AFTER AMPUTATION IN THE LOWER LIMBS AREA

Note! For professional adjustment, ask your retailer or other person who has
appropriate knowledge and qualifica�ons. Do not adjust inclina�on angle of
the seat by yourself.
• To adjust the centre of gravity, unscrew fixing screw in right and le�
wheel. Then, set the seat inclina�on by moving fixing axis of the wheel
upwards or downwards, the same in both wheels.
• The seat inclina�on should be set in such a way so that the user does not
slide down from the wheelchair and can freely use handrims.
SEAT BELT
The belt, which is included in the standard equipment, protects the trunk in cases
when the user slides down from the wheelchair or is not able to keep correct
posi�on independently. The belt is fastened with the use of buckle.
35