Description Of Functions; Technical Data - Parkside Pka 20-Li C3 Originalbetriebsanleitung

21 Charge level indicator
22 Battery release
23 Charger
(Fig. B)
24 Air inlet

Description of functions

As a compressor for inflating bicycle
tyres and inflatable toys, sports and
beach articles.
As an air pump for inflating and de-
flating large-volume inflatable items
for house-hold use.
Please refer to the descriptions be-
low for information on how the oper-
ating elements work.

Technical data

Cordless Compressor and Air
Pump .......................... PKA 20-Li C3
Rated voltage U
.........................20 V ⎓ (direct current)
Weight (without battery) .........≈1.6 kg
Max. air output
– Compressor ....................... 21 l/min
– Air pump .......................... 380 l/min
Max. pressure (Compressor)
................................ 10.3 bar (150 psi)
Sound pressure level (L
.............................. 70.8 dB; K
Sound power level (L
– Measured .... 82.5 dB; K
– Guaranteed ............................86 dB
Battery ...................................... Li-Ion
Temperature ............................≤50 °C
– Charging .............................4–40 °C
– Operation ........................... 4–50 °C
– Storage .............................15–25 °C
)
pA
=3 dB
pA
)
WA
=2.77 dB
WA
PARKSIDE Performance Smart
battery Smart PAPS 204 A1/
Smart PAPS 208 A1/
Smart PAPS 2012 A1
– frequency band ..2400–2483.5 MHz
– transmitted power ........... ≤ 20 dBm
Use hearing protection!
Notes on noise and vibration
values
Levels of noise and vibration were
determined according to the stand-
ards and regulations in the declara-
tion of conformity.
CAUTION! Hearing damage!
Wear ear protection.
The specified total vibration values
and the stated noise emission values
have been measured according to a
standardised test method and can be
used to compare one power tool with
another. The specified total vibration
values and the stated specified noise
emission values can also be used for
a provisional assessment of the load.
WARNING! The vibration and
noise emissions may deviate from the
specified value during actual use of
the power tool, depending on how
the power tool is being used and,
in particular, what kind of material
is being worked on. Safety meas-
ures for protection of the operator are
to be determined that are based on
an estimate of the vibration load un-
der the real operating conditions. All
parts of the operating cycle have to
be considered while doing so – for
example, times when the power tool
is switched off and times when it is
GB MT IE NI
27