Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.7 Connecting to several lights and controlling them using the DMX control
panel/remote control
• Connect the DMX control console, as described in point 10.6 to the device.
• Insert a compatible DMX control cable into the DMX output socket marked <DMX
OUT> or <DMX 2> (10).
• Insert the other end of the cable into the DMX input socket (9) of the second light
marked <DMX IN> or <DMX 1>.
• Set the correct DMX control channel on the 2nd light.
• Both LED lights are now controlled via the DMX signal of the remote control.
• Proceed in exactly the same way to control other lights.
For more details on DMX address setting, please refer to the table below and the
instructions for controlling a DMX.
11. Transporting, storing the device
WARNING
Danger of fire caused by hot parts of the equipment. Allow the device to cool
down completely.
•
Switch off the device (See „Switching the device on, off).
•
Allow the device to cool down completely.
•
Unplug the power supply cable from the device.
•
If necessary clean the device (See „Cleaning the device").
•
Lay the device and all disassembled elements into the original article packaging
box and transport of store as specified in the technical specifications. See
technical specifications.
60
12. Troubleshooting
Problem
Possible cause
The device is
Mains cable not plugged
switched on, but
in or not plugged in
does not show
correctly. Power packs are
any function.
almost exhausted.
The device is switched off.
LED lamps or
The device has not
display does not
enough power.
shine
The device is defective.
13. Maintaining the device
WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
Reinigen
WARNING
Danger of electric shock
■ Do not bring the device into contact with moisture or water.
■ Always pull out the power supply plug before starting to clean the device.
Device
Cleaning
Housing
Use a microfiber cloth to remove light and stubborn dirt.
Illuminant
Clean off dirt with a dust brush or a dry, soft cloth.
Remedy
Plug the mains cable in
correctly.
Charge the power packs.
Switch on the device.
Increase the power of the
dimmer control.
Connect our service.
61
Werbung
Inhaltsverzeichnis
