Cleaning And Disinfecting - Permobil Roho Agility Carbon Contour Back Support Bedienungsanleitung

Cleaning and Disinfecting

Warnings:
- Cleaning and disinfecting are separate processes. Cleaning must
precede disinfection. Before use by a different individual: clean,
disinfect, and check product for proper functioning.
- Follow safety guidelines on the chemical containers.
AGILITY Component
Back shell and hardware:
Cover:
Notes:
- Remove the foam pad from the cover
prior to cleaning and disinfecting.
Secure the hook and loop fastener
strips at both ends of the cover.
- Turn the cover inside out.
- Zip the cover closed to avoid snags.
Foam pad, foam insert and lumbar
support pad:
Note: Remove the foam pad from the cover
prior to cleaning.
Air insert:
Notes: Remove the air insert from the
cover and foam pad prior to cleaning and
disinfecting. Make sure the valve is closed.
DO NOT allow water or cleaning
solution to enter the air insert.
ROHO AGILITY CARBON Contour Back Support Operation Manual
To Clean:
Hand wash in warm (40°C) water with soap and a sponge.
Rinse with clean water. Wipe dry with a
clean cloth and then allow to air dry
completely.
Machine wash in warm (40°C) water with mild detergent.
Tumble dry low.
Wipe lightly with a damp cloth. DO NOT use soap. DO NOT
submerge in water. Wipe off with a clean cloth. Completely
air dry before replacing in cover.
Place in a large sink or basin with warm (40°C) water.
Hand wash, using mild liquid hand soap, hand dishwashing
liquid, laundry detergent, or a multi-
purpose detergent (Follow product label
instructions). Gently scrub all cushion
surfaces, using a soft, plastic bristle
brush, a sponge, or a cloth. Rinse with
clean water. Air dry. DO NOT machine
wash or dry. DO NOT expose to direct
sunlight.
Cautions:
- DO NOT use abrasives such as steel wool or scouring pads on the
product.
- DO NOT use cleaning products containing petroleum or organic solvents
[i.e. acetone, toluene, Methyl Ethyl Ketone (MEK), naphtha, dry cleaning
fluids, adhesive removers] on the product.
To Disinfect:
Wipe gently with a cloth dampened with a household
disinfectant. Rinse with clean water. Wipe dry with a
clean cloth and then allow to air dry
completely.
40C
Hand wash using quaternary ammonium disinfectant (Follow
product label instructions). Rinse thoroughly with clean water.
The cover may also be machine washed
40C
in hot (60°C) water to disinfect. Tumble
dry low. DO NOT use bleach.
Note: The method of disinfection should
be determined based on disinfection
needs.
Note: Disinfectants are NOT effective on porous surfaces
such as foam. Replace soiled or contaminated foam
components with authorized foam components only.
Replacement foam components may be purchased
separately. Soiled or contaminated foam components MUST
NOT be used by different individuals.
Hand wash in warm (40°C) water using 1 part household liquid
bleach per 9 parts water. Rinse thoroughly with clean water. Air
dry. DO NOT machine wash or
dry. DO NOT autoclave.
40C
16
or
60C
+
40C
= Wipe with damp cloth