Air Insert Adjustment; Flip The Back Shell - Permobil Roho Agility Carbon Contour Back Support Bedienungsanleitung

Air Insert Adjustment

Warnings:
- Check inflation frequently, at least once a day!
- The air insert must be used with the air cells facing the individual.
- The individual's comfort level may be reduced if the air insert is the wrong size, if
it is not positioned correctly or is under-inflated or over-inflated.
- If the air insert does not appear to be holding air, see "Troubleshooting." If the air
insert is still not holding air, replace the air insert with the foam insert and contact
Customer Support or your distributor.
- Changes in altitude may require adjustment to the air insert.
- Keep the air insert away from sharp objects.
Caution: If the air insert has been in temperatures less than 32°F / 0°C and exhibits unusual stiffness, allow the air insert to warm to room
temperature. Then open the inflation valve, roll up the air insert, and then unroll it until the polyurethane is soft and pliable again. Repeat adjustment
instructions before using.
To Adjust the Air Insert
Before adjusting the air insert, complete installation of the cover and AGILITY CARBON.
1. Slide the rubber nozzle of the hand pump over the inflation valve. Pinch
the nozzle and open the inflation valve. Inflate the air insert until it feels
firm.
3. The individual should
be seated in the
wheelchair in their
normal position. Open
the valve. Remove air
until the individual is
comfortable. Close the
valve.

Flip the Back Shell

1. Remove the product if it is already installed on
the wheelchair. See "Product Removal".
2. Rotate the back shell.
3. Follow all instructions to adjust and install the
product.
ROHO AGILITY CARBON Contour Back Support Operation Manual
Open
2. Pinch the rubber nozzle of the hand pump and close the inflation valve
4. Detach the cover flap
14
DO NOT:
- use the air insert as a seat cushion.
- use the inflation valve or hose as a handle to carry
or pull the air insert.
- use the air insert as a water flotation device (e.g., a
Life Preserver).
- use the following with an air insert: a pump, cover,
foam pad or repair kit other than those compatible
with your product. Doing so may void the product's
warranty.
completely. Remove the hand pump.
closest to the zipper.
Place the valve hose
inside the cover. Close
the zipper and reattach
the cover flap.
Close