eta RAGGIO Bedienungsanleitung Seite 71

6.7 MOP EXTENSION CLEANING
Remove the extension from the vacuum cleaner after each use. Pour excess water from
the reservoir. Rinse the mop extension under running water.
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by a professional service! Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to guarantee
repair!
7. PROBLEMS SOLUTIONS
Problem
Red light is flashing
slowly, and an
Dirt tank error
acoustic signal is
sounding
The dirt tank
5x acoustic signal
is full
A red light is flashing
Laser sensor slowly and 4x an
error acoustic signal is
sounding
Vacuum The red-light flashes
cleaner start and an acoustic
error signal sound twice
The red-light
Fault sensor
flashes slowly and
against falling
an acoustic signal
downstairs
sounds 3 times
The red-light flashes
IR sensor slowly and an
error acoustic signal sound
twice
Signalling
Incorrectly positioned or
missing dirt tank
The dirt tank is full, or
the filters are too dirty
Laser sensors are
obscured or is vacuum
cleaner placed in an
enclosed space
The vacuum cleaner is
raised or switched off
Stairway sensors are
covered / dirty, or the
vacuum cleaner is
placed too high
The IR sensor
protective glass is
covered or dirty
GB - 71
Cause
Place the dirt tank
correctly
Clean the dirt tank
and clean / replace
the filters
Check the laser
sensors and place the
vacuum cleaner in an
open space
Place the vacuum
cleaner on the floor
and switch it on
Check and clean the
fall sensor and place
the vacuum cleaner
on the floor
Check and clean the
IR sensor safety glass
GB
Solution