Service Functions - Carl Valentin Vita II Serie Kurzanleitung

Vita II

Service Functions

NOTICE!
So that the distributor res. the printer manufacturer at the case of service can offer fast support, the printer is
equipped with the Service functions menu.
Necessary information such as set parameter can read directly at the printer (see chapter 6.10 on page 53).
Keys: , , ,
Label parameters
Key:
Photocell configuration
Key:
Photocell parameters
Key:
Paper counter:
Key:
Heater resistance
Key:
Printhead temperature
Key:
Motor Ramp
Key:
Print examples
Key:
Input/Output
Key:
Cutter photocell
Cutter Home (CH)
98
, , , ,
Indication of label parameters in Volt.
A: Indication of minimum value.
B: Indication of difference between minimum and maximum value.
C: Indication of trigger level. The value is ascertained while measuring and can be changed.
This function enables definition of photocell levels.
In case of problems while positioning or measuring of label, levels for label photocell can be
set manually. Make sure that a large hub as possible (label >3 V, gap <1 V) is set.
TLS: Indication of transmission photocell level in Volt.
RLS: Indication of reflexion photocell level in Volt.
SLS: Indication of peel off photocell level in Volt.
RC: Indication of transfer ribbon photocell status (either 0 or 1).
H: Indication of printhead position.
0 = printhead down
1 = printhead up
D: Indication of printhead attainment in meters.
G: Indication of printer attainment in meters.
To achieve a high print quality, the indicated Ohm value must be set after an exchange of
printhead.
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current print
order is interrupted and an error message appears at the printer display.
This function is often used for high printing speed as the tearing of transfer ribbon can be
prevented.
The higher the '++' value is set, the slower the feeding motor is accelerated.
The smaller the '− −' value is set, the faster the feeding motor is decelerated.
Settings: Printout of all printer settings such as speed, label and transfer ribbon material.
Bar codes: Printout of all available bar code types.
Fonts: Printout of all available font types.
Indication of signal level which indicates the signal a print order is started.
0 = Low
1 = High
1 = Printer is equipped with a cutter
2 = Printer is not equipped with a cutter
1 = The cutter is in the initial position and ready for the cutting procedure.
0 = The cutter is not in the initial position. Before you are going to release a cutting procedure
you first have to place the cutter in its initial position.
English
, ,