Additional Accessories - Ryobi Rms-1830 Betriebsanleitung

GB
10.13 CLAMPING WIDE WORKPIECES
See Figure 33.
When cutting wide workpieces such as 50 mm (2") x 150 mm (6") boards, these should be clamped with a G-clamp
as shown in Figure 33.
Fig. 33
A. WIDE BOARD
11. MAINTENANCE
WARNING: To ensure safety and reliability and avoid the risk of personal injury, all repairs — except those involving
the externally accessible carbon brushes — should be performed by a qualified service technician at an Authorised
Ryobi Service Centre.
11.1 BRUSH REPLACEMENT
See Figure 34.
Your saw has externally accessible carbon brushes that should be periodically checked for wear.
Proceed as follows to replace the carbon brushes:
• Unplug your saw.
WARNING: Failure to unplug your saw could result in accidental starting causing serious injury.
• Remove the brush cap with a screwdriver. The brush assembly is spring-loaded and will pop out when you remove
the brush cap.
• Remove the brush.
• Check for wear. Replace both brushes when either has less than 6 mm (1/4") length of carbon remaining. Do not replace
one side without replacing the other.
• Always use new carbon brushes when replacement is required. Make sure the curvature of the brush matches
the curvature of the motor and that the brush moves freely in the brush tube.
• Make sure the brush cap is positioned correctly (straight) and put it back in place.
• Tighten the brush cap securely. Do not overtighten.
Fig. 34
A. CARBON BRUSH
B. BRUSH CAP
12.

ADDITIONAL ACCESSORIES

12.1 ACCESSORIES
• Clamp assembly
• Clamp support
• Clamp extension rod
• Extension arm (2)
• Clamp bracket (2)
• Clamp bracket screw (2)
• Small screws (4)
Fig. 35
A. CLAMP EXTENSION ROD
B. EXTENSION ARM
C. CLAMP ASSEMBLY
D. CLAMP BRACKET
12.2 INSTALLATION
WARNING: To prevent the saw starting accidentally and possibly causing serious personal injury, fit all accessories
to your saw before plugging it in. Always unplug your saw before fitting parts, making adjustments, attaching or
removing a blade, or when you are not using your saw.
C. CARBON BRUSH
D. BRUSH CAP
E. CLAMP BRACKET SCREW
F. CLAMP SUPPORT
G. SMALL SCREW
42