Storage; Transport; Troubleshooting - Parkside Performance Ppaks 40-Li B2 Originalbetriebsanleitung

7. After resetting, round off the depth gauge
slightly towards the front.

Storage

• Remove the rechargeable batteries.
• Clean and maintain the tool prior to stor-
age.
• Attach the chain guard (22).
• Empty the oil tank prior to longer peri-
ods of non-use. Dispose of waste oil
environmentally correctly (Disposal/
environmental protection, p. 46).
There may still be oil residues within
hoses and in the tool that could leak out
during storage. Place the tool on a suit-
able base/oil pan for storage.
• Store the tool in a dry and dustproof loca-
tion and out of reach of children.
Devices with battery:
• The storage temperature for the bat-
tery and device is between 15 °C and

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Poor cutting performance
Device has difficulties running,
saw chain jumps off
Saw chain gets hot, smoke de-
velopment when sawing, dis-
colouration of the rail
25 °C. Avoid extreme cold or heat during
storage to ensure the battery output is
not adversely affected.
• Remove the battery from the device be-
fore storage over a longer period (see
separate operating instructions for battery
and charger).

Transport

• Switch off the tool each time before
transport, engage the chain brake and re-
move the batteries.
• Cover the blade bar and saw chain with
the chain guard (22) when you transport
the tool.
• Short distances at the place of work:
Carry the tool by the front handle (11) with
the blade bar pointing backwards.
• Secure the tool against tipping over dur-
ing transport (including in vehicles) to pre-
vent injury, damage or loss of fuel.
Possible cause
Batteries (17) empty or not in-
serted
On/Off switch (2) is broken
Defective motor
Saw chain (6) incorrectly fitted Installing the saw chain and
Saw chain (6) blunt
Insufficient chain tension
Insufficient chain tension
Not enough chain oil
GB
Error correction
Check battery charge level, re-
pair by a qualified electrician if
necessary
contact the service centre.
blade bar, p. 43
• Sharpening the cutting
teeth, p. 44
• Running in a new saw
chain, p. 43
Tensioning the saw chain,
p. 37
Tensioning the saw chain,
p. 37
• Checking the oil level and
oil automation
• contact the service centre.
MT
45