Maintenance - Parkside Performance Ppaks 40-Li B2 Originalbetriebsanleitung

GB
MT
Clean the machine thoroughly. This will ex-
tend the life of the machine and prevent ac-
cidents.
Cleaning after every use
• Keep the handles free of petrol, oil or
grease. If necessary, clean the handles
with a damp cloth washed in soapy water.
• Clean the saw chain. Do not use any li-
quids to clean the saw chain. Lightly oil
the saw chain with chain oil after clean-
ing.
• For cleaning, also remove the sprock-
et cover (9) so that this area can also be
cleaned.
• Clean the blade bar (5)
Machine part
Chain brake
components
Sprocket (26)
Saw chain (6)
Saw chain (6)
Blade bar (5)
Blade bar (5)
Automatic oil system
Mounting the saw chain and blade bar
CAUTION! Cutting injuries! Wear cut-
resistant gloves when working with the saw
chain or with the blade bar.
Procedure
1. Switch off the tool and remove the bat-
teries (17) from the tool.
2. Place the device on a level surface.
3. Deactivate the chain brake: Pull the chain
brake lever (4) back towards the front
handle (11).
You can only refit the sprocket cover (9)
when the chain brake band has been re-
leased.
4. Turn the wing screw (7) and rotary wheel
for chain tensioner (8) ⭯ to loosen the
chain tension and remove the sprocket
cover (9).
5. Remove the sprocket cover (9).
42
Action
Visual inspection, re-
place as needed
Visual inspection, re-
place as needed
Check saw chain, oil, reg-
rind or replace if necessary
Clean and oil the saw chain
Servicing the blade bar, p. 43
Turning the blade bar, p. 44
Check, clean oil pas-
sage if necessary
• Clean the ventilation slits and the surface
of the machine with a paintbrush or dry
cloth.
• Clean the oil passage (23) to ensure fault-
free, automatic oiling of the saw chain
during operation. Use a brush or a cloth
to help remove residues from the oil pas-
sage.

Maintenance

Service intervals
Carefully perform the maintenance tasks lis-
ted in the following table on a regular basis.
Regular servicing of your device will extend
its life. Additionally, you will achieve optimum
cutting performance and prevent accidents.
Before
each use
✓
✓
✓
✓
✓
6. Push the blade bar (5) towards the chain
sprocket (26).
You can remove the saw chain (6) and
blade bar (5).
Changing the saw chain and blade bar
Prior to changing the saw chain, the groove
of the guide rail must be cleaned of dirt be-
cause dirt deposits available can cause the
saw chain to break out of the rail. The de-
posits can also absorb the chain oil. So the
consequence would be that the chain oil
would not or only a small part of it would
reach the underside of the rail and the lubric-
ation would be reduced.
WARNING! Risk of injury! The use of un-
authorised combinations of blade bar and
saw chain can lead to an increased risk of
kickback.
After 10 After
hours each use
of use
✓
✓
✓