Start-Up; Start Delay And Overrun Time; Wireless Components - Maico ECA 150 ipro Montage- Und Betriebsanleitung

uk │ 7. Installation – Sensor and covers
2. For models B, KB, H, KH, RCH and
KRCH, insert the sensor supplied [9] in
the correct position ( arrows) in the
connector base.
3. With setting buttons [11] and [12], set the
start delay and/or overrun time as
described in Chapter 7.4.
4. On fans with radio electronic unit (RC,
KRC, RCH and KRCH units), set up
wireless components with setting button
[11] ( Chapter 8).
5. Carefully press cover [7] (with designer
cover [8]) on to housing [2] until it engages
with the catch ( fig. A).

7.3 Start-up

1. Switch the mains fuse on.
2. Carry out a function test.
3. Set up RC, KRC, RCH and KRCH units as
described in Chapter 8.
26

7.4 Start delay and overrun time

When you press setting button [11]
or [12] for the first time, the current
setting is indicated by the LEDs. Du-
ring operation, all LEDs are then off.
The delivery status can be seen in
the table ( Chapter 2.1).
1. Remove unit cover [7]/[8] as described in
Chapter 6. To release the cover, push the
catch up with a screwdriver.
2. Set start delay: Press setting button [11]
until the LED for the start delay time you
want lights up. Wait until the LED flashes
twice and goes out. The value is now
saved.
3. Set overrun time: Press setting button [12]
until the LED for the overrun time you want
lights up. Wait until the LED flashes twice
and goes out. The value is now saved.
The settings take effect during the
next switch process (sensor, light
switch).
4. Carefully press cover [7] (with designer
cover [8]) on to housing [2] until it engages
with the catch ( fig. A).

8. Wireless components

For the function of wireless
components, see  description of
Maico Smart in Chapter 2.7. For
program levels  Chapter 2.9.
To set up the RC fans, remove and
then refit cover [7]/[8] as described
in Chapter 6.
Receivers = Fan(s) ECA 150 ipro
RC/KRC/RCH/KRCH, as either master or
slave unit in the network.
Transmitters = Room air control RLS RC,
radio switch, wireless window contacts, fan(s)
ECA 150 ipro RC/KRC/RCH/KRCH as slave
unit(s).