Herunterladen Inhalt Inhalt Diese Seite drucken

Safe And Correct Practices During Operation; Installation Preparations - Maico ECA 150 ipro Montage- Und Betriebsanleitung

Kleinraumventilator
Vorschau ausblenden Andere Handbücher für ECA 150 ipro:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5.2 Safe and correct practices
during operation
Danger of injury in case
of objects in the impeller.
Do not insert any objects
in the unit.
Danger of injury from
rotating impeller. Do not
get too close to the unit,
to avoid hair, clothing or
jewellery being drawn into
the unit.
● This fan unit can be used by
children aged 8 and above,
and by people with reduced
physical, sensory or mental
capabilities or by persons with
insufficient experience or
knowledge provided they are
supervised by a person
responsible for their safety,
or they have been instructed
about the safe operation of
the unit and can understand
the resulting risks thereof.
Children must not play with
the unit. Cleaning and
maintenance must not be
carried out by children without
supervision.
5. Safety instructions │ uk

6. Installation preparations

Wall
The prescribed minimum distances
between the unit and the wall and
ceiling shown in figure D must be
observed.
1. Make sure the housing has a level base.
2. Fit wall breakthrough or drill core hole:
minimum diameter, 150 mm.
Recommendation: Fit wall sleeve
WH 150. Fit wall breakthrough with
minimum diameter 170 mm.
3. Lay power cable to installation location
(surface-mounted (AP) or recessed-moun-
ted (UP)); for clearances see  Fig. D.
Always note the relevant specifica-
tions for electrical installations and
when fitting equipment. In Germany
observe DIN VDE 0100 and the
corresponding parts in particular.
Ceiling
Danger of short-circuits and
NOTICE
damage to unit if
condensation builds up in the
fan housing.
Thermally insulate ventilation
ducts in professional manner.
Allow for a condensation drain or
condensate collector in the riser.
Prepare for mounting as described above
under 'Wall'.
Duct
1. Debur edges on the inside of the duct.
2. Prepare for mounting as described above
under 'Wall'.
Fan
1. Unpack unit and dispose of packaging
( Chapter 15.)
2. Remove cover [7]/[8]. To release the
cover, push the catch up ( fig. A, arrow).
23

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis