Adjustments; General; Setting For Concrete Kerbs; Adjustment Support Rollers - Probst Rf-H Betriebsanleitung

Adjustments

3 Adjustments
3.1

General

The device (RF-H) must be adjusted to the concrete subgrade removal height, concrete subgrade width and
kerbstone width before starting work. Caution: Risk of injury to hands!
3.2

Setting for concrete kerbs

•
Remove all three eyebolts (1).
Adjust to the specific width of the curb by sliding the
puller plate (2) back and forth.
•
Tighten the eyebolts (1) again.
3.3

Adjustment support rollers

The support roller (3) (rear side of the pull-off plate
(2) must be in direct contact with the curb as support
for the unit (RF-H).
Adjustment: loosen all 3 eyebolts (5); move support
roller (3) and tighten all 3 eyebolts (5) again.
3.4

Adjustment of the pull-off height (concrete subgrade)

•
Loosen the eyebolt (6).
•
Set the desired height of the concrete level by pushing up or
pulling down the height adjustment (7).
•
Tighten the eyebolt (6) again.
51000064
5
3
7 / 11
Pulling direction
Adjustment of pull-off
height
Setting for kerb width
1
2
6
4
GB