Battery Charge State Indicator; Remaining Range Indicator; Units; Programming And Settings - Derby cycle Impulse 2.0 Ergo Originalbetriebsanleitung

7.2.2 Battery charge state indicator

The battery charge state indicator is located at the top
right of the display. Using a battery symbol divided into
seven segments, it shows the charge remaining in the
battery. The lower the charge state of the battery, the
fewer segments are displayed.
DISPLAY BATTERY CHARGE STATE
100-85.5%
85.5-71.5%
71.5-57.5%
57.5-42.4%
42.5-28.5%
28.5-14.5%
If the battery charge state falls below a minimum level,
the motor assistance switches of. Then the entire display
fades and goes of, too.
If you do not use your Pedelec for ten minutes, the
system switches of automatically. If you then want
to ride using the assistance, you will have to switch it
back on via the control unit.

7.2.3 Remaining range indicator

Below and to the right of the battery charge state indica-
tor, the distance in km over which you can still travel with
power assist is displayed. This is the remaining range
indicator.
If the riding conditions change, for example, when
you come to a hill ater a long, lat stretch, the value
displayed can also change at short notice. Please
consider this factor when planning your trips. You are
probably familiar with this efect rom the remaining
range indicator of your car. The remaining range de-
22 Original User Manual | Pedelec Impulse 2.0 Ergo
pends on the current battery charge state and the as-
sist mode which has been set (ERGO, POWER, SPORT
or ECO).

7.2.4 Units

Press and hold the button for three seconds to switch
between kmh (speed)/ km (remaining range indicator) and
mph/mi.
7.3

Programming and settings

Ater switching on the Impulse system, you can switch
rom the main menu to the menu sub-items, by pressing
the button for three seconds.
This takes you to the menu sub-items:

• Drive data

Chapter 1.2.1
• Delete trip data
• Delete overall data
• Device settings Chapter 7.3.4
• Personalize Chapter 7.3.5
• Target cost Chapter 7.3.6
Chapter 7.3.7
• ERGO settings
• Back
You can select the menu sub-items using the
on the control unit. Conirm your selection by pressing the
button. The respective contents are then displayed for
you. To return to the main menu display rom the menu
sub-items, you must select "Back" and conirm by press-
ing the button. You can also return to the main menu by
pressing and holding the
7.3.1 Drive data
The following data are displayed in the menu sub-item
"Drive data":
• Trip (in km)
• Trip time (in 00:00:00)
• Trip max (in km/h)
• Trip Ø (in km/h) = Trip average
• Trip cost (in €)
• Tour (in km)
• Tour Ø (in km/h) = Tour average
• Tour cost (in €)
• Overall (in km)
• Overall savings (in €)
• Tot. sav. CO2 (in kg)
• Back
Chapter 7.3.2
Chapter 7.3.3
/ buttons
button for three seconds.