Control Unit And Display; Control Unit; Switching On/Of; Pushing Assistance - Derby cycle Impulse 2.0 Ergo Originalbetriebsanleitung

SEAT TUBE BATTERY
Battery in the docking station
If a charging fault occurs, the LED (where present)
in the charger lashes red. In this case, the charging
current is too high. Disconnect the battery rom the
charger and then connect it again. If the error mes-
sage still appears, the battery and charger must be
checked by a specialist cycle shop.

7 Control unit and display

The Pedelec Impulse 2.0 Ergo can be controlled via two
elements: the control unit on the handlebar grip and the
display in the middle of the handlebar.
7.1

Control unit

1
2
3
4
Press the button to switch the system on and of. But-
tons 2 to 4 have diferent unctions depending on the
menu item you have selected.
20 Original User Manual | Pedelec Impulse 2.0 Ergo

7.1.1 Switching on/of

Press the
pulse system on. Ater a few seconds, the welcome screen
appears, followed by the start menu. From there you can
carry out urther settings
Ater switching on, the system is always in the same
display mode as when you last switched it of.
To switch your Pedelec of, press the
trol unit in the start menu.

7.1.2 Pushing assistance

The pushing assistance moves the Pedelec slowly (at a
maximum speed of 6 km/h) without you having to turn the
pedals, e.g. if you are manoeuvring in a tight space or are
pushing your Pedelec out of a basement garage.
To activate the pushing assistance, press the
three seconds.
The pushing assistance is not suitable for use as
starting assistance.
7.1.3
1 button
2 button
3 button
4 button
button on the control unit to switch the Im-
Chapter 1.1 "General".

buttons

/
• You can speciy the power-assist level via the
/ buttons.
• Each time you press one of these two buttons, the
power assist changes by one level. If you press the
button once, the level of assistance increases by
one level. If you press the
sistance becomes weaker by one level.
button on the con-
button for
button once, the as-