Battery Information System; Checking The Charge State; Checking The Capacity - Derby cycle Impulse 2.0 Ergo Originalbetriebsanleitung

DOWN TUBE BATTERY
Locking the battery
3. Make sure the battery is irmly in place.
5.2

Battery information system

There is a display panel on the outer face of the battery
which includes ive LEDs and a battery key | push button.
The LEDs light up as soon as you press the battery key
| push button. The charge state and capacity of the battery
is indicated by the number of LEDs that light up and the
way in which they light up.
DOWN TUBE BATTERY
Battery key

5.2.1 Checking the charge state

a) Down tube battery: Press the battery key briely. The
LEDs light up and display the current battery charge state.
DISPLAY
•••••
5 LEDs light up
••••
4 LEDs light up
•••
3 LEDs light up
••
2 LEDs light up
•
1 LED lights up
1 LED lashes
b) Seat tube battery: Press the push button briely. The
LEDs light up and display the current battery charge state.
SEAT TUBE BATTERY
SEAT TUBE BATTERY
Push button
BATTERY CHARGE STATE
100-80%
80-60%
60-40%
40-20%
20-10%
10-0%
SEAT TUBE BATTERY DISPLAY
.
•••••
5 LEDs light up
••••
4 LEDs light up
•••
3 LEDs light up
••
2 LEDs light up
•
1 LED lights up
1 LED lashes
5 LEDs lash quickly
1st LED lashes
quickly
* All 5 LEDs lash quickly: The battery is a) empty and is
being switched of, or is b) overloaded.
a) If the battery is overloaded, it will switch back on ater
a short idle period and can then be used normally.
b) If the battery is empty, it will work again briely fol-
lowing a short period of rejuvenation and will then
switch back of. It must now be charged.
** The 1st LED lashes quickly: a charging fault.
If this occurs, put the battery in the docking station for a
short period of time or insert the plug of the charger into
the battery. The charger performs a readjustment. If the
LED still lashes, take the battery to your specialist cycle
shop.

5.2.2 Checking the capacity

a) Down tube battery: If you hold down the battery but-
ton for roughly ive seconds, the LEDs show the current
battery capacity. If the LED in the largest panel lights up,
then the battery has a capacity of over 60%. If the capac-
ity is below 60%, this is indicated via the smallest LED.
Only one of the two LEDs can light up at any one time.
b) Seat tube battery: If you press the push button for ive
seconds, the LEDs show the current capacity of the bat-
tery.
SEAT TUBE BATTERY DISPLAY
•••••
5 LEDs light up
••••
4 LEDs light up
•••
3 LEDs light up
••
2 LEDs light up
•
1 LED lights up
1 LED lashes
Original User Manual | Pedelec Impulse 2.0 Ergo
BATTERY CHARGE STATE
100-84%
83-68%
67-51%
50-34%
33-17%
16-0%
0% or overloaded *
Charging fault **
CAPACITY
100-97%
96-80%
79-60%
59-40%
39-20%
< 20%
17