Herunterladen Inhalt Inhalt Diese Seite drucken

Quick Start - Derby cycle Impulse 2.0 Ergo Originalbetriebsanleitung

Pedelec
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4 Quick start

1. Charge the battery completely before riding for the
irst time. Charge temperature: 0°C to 45°C.
SEAT TUBE BATTERY
Charging the battery
2. Remove the cover rom the charging socket.
3. Connect the plug of the charger to the battery.
DOWN
TUBE
BATTERY
Charging the battery
4. Plug the charger in at the wall socket.
You must charge the battery completely before
using it for the irst time. Depending on the
manufacturer of the cells, the batteries will have
a charge state of between 30 and 50%.
You can also remove the battery rom your
Pedelec and charge it elsewhere. For more
information, refer to ¡ Chapter 5 "Battery".
5. Once all of the battery LEDs have gone out, the battery
is ully charged. Pull the plug of the charger out of the
charging socket and unplug the charger at the wall
socket.
6. a) Down tube battery: If you removed the battery for
charging, replace it in the holder rom the ront/above.
At the same time, the key must be in the lock and must
be turned anticlockwise. Press the battery down into
the holder until the locking mechanism engages.
10
Original User Manual | Pedelec Impulse 2.0 Ergo
SEAT
TUBE BATTERY
6. b) Seat tube battery: If you removed the battery for
charging, reinsert the battery into the holder on the
Pedelec rom the let-hand side. Tilt the battery out-
wards at an angle of roughly 45° as you do so. Swivel
the battery into the upright position until the locking
mechanism engages. Now turn the key clockwise and
remove it. The battery is now locked in place.
DOWN TUBE
BATTERY
Installing the battery
7. Now turn the key clockwise and remove it. The battery
is now locked in place.
DOWN TUBE
BATTERY
Locking the battery
8. Make sure that the battery is securely positioned and
that the key is no longer in the lock.
9. Press the
button on the control unit to switch on the
drive system.
10. a) Pedelec without backpedal unction: Ater the wel-
come screen, the display shows the power-assist mode
that was last set. Press the
the level of assistance: ECO (low), SPORT (medium),
POWER (high), ERGO (heart-rate-controlled) or no as-
sistance. Pressing once changes the level of assistance
by one level. This works both ways, depending on
which of the buttons you press.
SEAT TUBE
BATTERY
SEAT
TUBE BATTERY
/
buttons to select

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis