Riding In The Ergo Power-Assist Mode - Derby cycle Impulse 2.0 Ergo Originalbetriebsanleitung

10. b) Pedelec with backpedal unction: Ater the welcome
screen, the display shows "Please move the pedals".
This instruction will disappear as soon as you start
riding. Press the /
assistance: ECO (low), SPORT (medium), POWER (high),
ERGO (heart-rate-controlled) or no assistance. Pressing
once changes the level of assistance by one level. This
works both ways, depending on which of the buttons
you press.
If you cannot feel any assistance, simply backpedal
briely and then pedal forwards again to trigger the
system check. If there is still no assistance being
delivered, the instruction "Please move the pedals"
will continue to be displayed. In this case you should
consult your specialist bike shop.
11. You can now ride of just as you would if you were
riding a normal bike. The motor starts providing assis-
tance as soon as the rear wheel starts turning.
From the irst moment, you have ull assistance. This
is unfamiliar but comfortable. Practice starting up in a
safe location before venturing into the road traic.
buttons to select the level of
4.1 Riding in the ERGO power-assist
mode
1. Follow steps 1 to 9 in
2. Put on the chest belt supplied. Ensure that it does not
slip and that the electrodes are always in contact with
the skin.
Chest belt
Moisten the reverse of the chest belt with electrode
gel or water before putting it on.
3. Navigate to the ERGO power-assist mode using the
/ buttons. The notiication "Determine heart rate
..." appears on the display.
As soon as the heart rate is displayed, you can adjust
the settings urther.
Original User Manual | Pedelec Impulse 2.0 Ergo
Chapter 4 "Quick start".
11