Installing The Battery - Derby cycle Impulse 2.0 Ergo Originalbetriebsanleitung

If your charger has an LED, it may be that this lashes
red permanently. This indicates a charging fault. Take
the battery out of the charger, then put it back in. The
charger tests the battery and performs readjustments,
if required. If the LED on the charger still lashes, take
the charger and battery to your specialist cycle shop
who will test the device and replace it, if required.
4. To save power, pull the charger plug out of the socket
once the charging operation is complete.
Damaged batteries must not be charged, and
urther use is not permitted.
The battery may heat up during charging. A maxi-
mum temperature of 45°C may be reached. If the
battery becomes any hotter than this, stop the
charging process immediately.
16 Original User Manual | Pedelec Impulse 2.0 Ergo
There is no memory efect, so you can top up
your battery ater every trip. Then you are always
ready for the of.
Ideally you should charge the battery at a tem-
perature of between +10°C and +30°C. It takes
longer to charge the battery at low temperatures,
while the battery will not charge up at tempera-
tures higher than +45°C. Ideally, you should
charge and store the battery inside your house or
in a warm garage when the outside temperature
is low. In this case, you should only it the bat-
tery onto your bike just before using it.

5.1.3 Installing the battery

1. a) Down tube battery: Insert the battery into the bat-
tery holder of the Pedelec rom the ront/above. At the
same time, the key must be in the lock and must be
turned anticlockwise.
1. b) Seat tube battery: Insert the battery into the holder
of the Pedelec rom the let by tilting it outwards at
roughly 45°.
DOWN TUBE BATTERY
Installing the battery
2. Press the battery down into the holder until the lock-
ing mechanism engages. Now turn the key clockwise
and remove it. The battery is now locked in place.
SEAT TUBE BATTERY