Start A Measurement - Pce Instruments Pce-Vdl 16L Benutzerhandbuch

6.8

Start a measurement

To prepare a new measurement for the "VDL X", click on the icon in the group "Data Logger".
In the window that is now displayed, not only the involved sensors can be set but also the start
and stop conditions.
In the „Sensors" area, the available sensors of the data logger can be included in a measurement
by ticking the box in front of the sensor name. At the same time, you can set if the LOG LED
should flash during the measurement.
You can also set a sampling rate for each sensor.
For the temperature, humidity, pressure and light sensors, you can set a sampling rate between
1 and 1800 s (30 minutes).
The smaller the value entered, the more measurements are made.
For the acceleration sensor, you can select a value between 1 and 800 / 1600 (depending on
your requirements).
The higher the value entered, the more measurements are made.
You can also set alarm values for the temperature, humidity, pressure and light sensors.
© PCE Instruments
43
Downloaded from www.Manualslib.com manuals search engine