PCE Instruments PCE-VDL 16l Benutzerhandbuch Seite 49

You can set a minimum value as the lower limit and maximum value as the upper limit.
If the measured value of at least one of these sensors is outside this set range, the data logger's
LED will flash in red.
The red LED will go off as soon as all readings are back within the set range.
A measurement can be started in three different ways:
- Instant:
When the window for starting a measurement is closed by clicking on „Apply", the measurement
is started.
- By keystroke:
The measurement is started when the Start or Stop key of the data logger is pressed.
- By time:
You can set a date and time for starting a measurement.
Note 1:
By clicking on the „By time" button, you can take over the current time of your PC as the time
shown in that window.
Note 2:
The data logger synchronizes its internal clock with the PC time every time a new measurement
is prepared.
A measurement can be stopped in two different ways:
- By keystroke:
The measurement is stopped when the Start or Stop key of the data logger is pressed.
- By time:
You can set a date and time for stopping a measurement.
Note:
By clicking on the „By time" button, you can take over the current time of your PC as the time
shown in that window.
Of course, an ongoing measurement can always be terminated manually via the software, by
in the group "Data Logger".
clicking on the icon
© PCE Instruments
44
Downloaded from www.Manualslib.com manuals search engine