Connect To The "Pce-Vdl X; Disconnect From The " Pce-Vdl X; Switch Off The Data Logger - Pce Instruments Pce-Vdl 16L Benutzerhandbuch

"Only show windows of current series of measurements" hides views that do not belong to the
currently selected series of measurements.
When this mode is active, the lower status bar of the main window will show the text "Single".
If you select "Show all windows of each series of measurements" instead, all views of all loaded
series of measurements will be shown.
In this case, the lower status bar of the main window will show the text "Multiple".
Via the button "Change...", the standard size of the windows for all views can be set.
6.2
After the desired settings have been made, close the Settings window by clicking on the "Apply"
button.
Turn on the data logger before you proceed.
Press the
The LOG LED starts flashing approx. every 10 seconds.
Now click on the
If the connection could be successfully established, the status bar for dynamic data will show, for
example, the following in green:
If the button changes to
6.3
By clicking on the
icon
By clicking on the
6.4
When the data logger is on, the LOG LED flashes.
Press the
data logger. In the display field of the status bar, you will see the following in green:
If the data logger is turned off manually, a new configuration via the
Logger" is required, see chapter "Start a measurement".
Downloaded from www.Manualslib.com

Connect to the "PCE-VDL X"

key.
icon in the toolbar of the main window, in the group „Connection".
, this means that the connection is active.

Disconnect from the " PCE-VDL X"

icon, an active connection to the "PCE-VDL X" can be terminated. The
indicates that the connection has been interrupted.
icon, an active connection to the "PCE-322A" can be terminated.

Switch off the data logger

key when the meter is on to stop the LOG LED from flashing and to switch off the
manuals search engine
© PCE Instruments
39
button in the group "Data