Measurement; Settings; Zero Adjustment; Hold Measurement - Pce Instruments Ram 100 Bedienungsanleitung

6

Measurement

6.1

Settings

Before starting a new measurement, select the following parameters:
Unit of radiation (µSv/h or mrem/h)
Unit of the pulses (CPS or CPM).
Ticker on / off
Accumulation time
Counting duration
Alert on / off
Isotope
6.2

Zero adjustment

Press the BACK key for 2 seconds in any measurement screen to reset the measured value
and start a new measurement. After pressing it, the following dialogue is shown on the screen:
6.3

Hold measurement

Enabling or disabling to hold the current measurement values is possible by pressing the OK key
for 1 second. This is possible in any measurement screen.
When the hold option is selected, "HOLD" is displayed at the top and central part of the screen.
The measurement will then be stopped and the values of the last measurement are held on the
screen.
© PCE Instruments
45