Eliminating Minor Faults Yourself - Bosch KIF42 SERIE Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Temperature display
indicates "E..".
The light does not function.
Appliance is not cooling,
temperature display and light
are lit.
The temperature
in the refrigerator
compartment is too cold.
Possible cause
Electronics have detected
a fault.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
Showroom mode is
switched on.
Freezer compartment door is
open.
Temperature has been set
too low.
The Super function is
switched on.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Call customer service.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
Close the freezer compartment door.
The freezer compartment door engages
audibly.
Increase the temperature.
Switch off Super function.
en
39