KORADO Z-TB-RF Handbuch Seite 177

AMBIENT TEMPERATURE SENSOR SETTINGS
• Overview
Important: This operation is reserved for professional installers only; any
improper change would result in control anomalies.
If the measured ambient temperature (as measured by a reliable thermometer) differs
by at least 1°C or 2°C from the setpoint temperature of the radiator, calibration will
adjust the temperature measured by the ambient temperature sensor to compensate
for the deviation from +5°C to - 5°C in 0.1°C steps.
• Ambient temperature sensor settings
1. If the ambient temperature difference is negative, for example:
Temperature settings (desired) = 20°C
Ambient temperature (measured with a reliable thermometer) = 18°C
Measured difference = -2°C
Important: It is recommended to wait 4 hours after changing the set
temperature before performing the calibration to allow the ambient
temperature to stabilize.
Follow the following steps to modify:
Sensor temperature = 24°C
(The measured temperature may vary depending on
the location of the remote controller in the room).
Decrease the temperature measured by
the ambient temperature sensor by 2°C
by pressing .
In our example,
measured by the sensor is reduced from
24°C to 22°C.
the temperature
53
EN