KORADO Z-TB-RF Handbuch Seite 152

4. The P1 start time (which defaults to
06:00) will flash. Use
change this time in 30-minute steps.
Save by pressing the
EN
5. The P1 end time (which defaults to
22:00) will flash. Use
change this time in 30-minute steps.
Save by pressing the
6. Once all days of the week are programmed, press the
programming mode and return to Automatic mode.
Note: Without pressing the buttons, the device returns to the Automatic mode after
a few minutes.
• Selecting and assigning programmes
1. If you have just set the time and day, you will see prog. Briefly press the
button. From the Automatic, Comfort, Eco or Freeze Protection mode, press the
button for 5 seconds.
When the day and time symbol
or to
button.
or to
button.
appears, press the
28
button twice to exit
button again.