KORADO Z-TB-RF Handbuch Seite 133

RADIO LINK BETWEEN THE REMOTE CONTROLLER
AND THE REMOTE-CONTROLLED DEVICE
The remote controller has been designed for wireless control of heating equipment
equipped with a radio receiver. Radio waves are used for communication.
This operation manual only describes instructions for mutual pairing. For
information on installing and using your heater, please refer to its operation
manual.
- Radio pairing between the room temperature controller and the radiator
(heater)
The remote controller and the heater are not paired at the factory, proceed as follows:
1. Proceed to pair the heater control (see the installation and operation manual).
2. Then switch the remote controller to pairing mode. From the Freeze Protection
mode, press the
To cancel the pairing process, press any button.
button for 5 seconds.
9
5 s
EN