KORADO Z-TB-RF Handbuch Seite 135

5. When the device and the remote controller
are connected, the
permanently. The device will automatically
return to the Freeze Protection mode. The
remote controller now takes over control
of the paired ventilation units. Only the
main switch remains active on the units.
• Checking radio signal strength
Important: Before proceeding to check the controller, make sure that the
remote controller and the heater are in their final location (see the section
Installation, page 4) and paired (see the previous paragraph "Radio connection
between the remote controller and the remote-controlled device").
You can check the quality of the radio connection between one device and the remote
controller at any time.
To display the radio signal level for a specific device, press the
seconds in the Freeze Protection mode. The display will then show the level for device
1.
0 = High level of radio signal quality, the location of the remote controller is
optimized.
9 = Low level of radio signal quality.
To improve the radio signal level between two devices
and ensure that remote management is optimized:
- Make sure that the radio transmission is not interfered with.
- Move the remote controller closer to the device.
symbol appears
11
EN
button for 5