Network Mode - Connect Several Tsc's - Proled Touch Control Lcd Rgb Dmx Benutzerhandbuch

If a program is assigned to one contact, on the right lower side a small 'S' or 'P' is
displayed. S means switch type, P means push type.
NETWORK MODE – CONNECT SEVERAL TSC's
It is possible to connect more TSC via IMC line and this network mode has several
advantages. The connected TSC's can reach all other zones.
 From different places the same zone can be reached
 With one TSC more than four zones can be control
The network mode must be enabled for each device in MENU – INTER MODULE
COMMUNICATION. There can be also to set a unique network name, it will make
easier to identify the device on the other screen.
You can also set custom names for each zone. It will help to identify the zones on the
other device screens.
If the network mode is enabled and more devices are connected to the IMC line, then
the network connection will be automatically detected and is ready to use. The IMC
icon on the header line is yellow during detection process and will be green if the
connection is OK.
In program mode touch the IMC icon on the header line and IMC DEVICE
SELECTION window will open. Now the connected IMC devices are displayed. In
program mode the selected device zones can always be seen.
Touch the CLOSE button to activate the selection.
If in MENU – PROGRAM WINDOW the check box IMC DEVICE SELECTION IN
FOOTER LINE is on, then it is possible to select another connected TSC's directly in
the footer line of program window.
If more TSC are connected in the IMC line, only one of them will send its DATE/TIME
data and the others are synchronizing automatically.
07.19 Technical amendments reserved
MBN GmbH

Balthasar-Schaller-Str. 3
www.proled.com
Montageanleitung / Installation manual

86316 Friedberg

Germany
47