Program Mode; Master Slider; Add New Program - Proled Touch Control Lcd Rgb Dmx Benutzerhandbuch

Montageanleitung / Installation manual

PROGRAM MODE

The program window is divided in four parts, these are the four zones. Different
components can be seen in this window. It depends on the settings in the PROGRAM
WINDOW and the APPEARANCE menus.
If zone names are set, then their names are displayed. A modification of the zone
names is possible by longer touching the name area.

MASTER SLIDER

If the master slider is switched on in PROGRAM WINDOW menu, then on the right
side of each zone window a slider will be displayed. These sliders reduce the current
output brightness. If this master slider is not enabled, then there is no reduction of the
output values and only the programmed colors can be seen at the output.

ADD NEW PROGRAM

Touch the '+' button to add new program buttons to the zone. After touching the '+'
button the manual window will open. Select any color – as described in MANUAL
MODE menu - and press OK. One program button will be seen in the zone.
Up to six programs can be added to each zone.
Touch the program button to start the program and touch again to stop it. Only one
program can be run in one zone at the same time. If there are more program buttons
in the same zone and already one only runs, then starting another program will
automatically stop the running one.
  
MBN GmbH Balthasar-Schaller-Str. 3 86316 Friedberg Germany
42
www.proled.com