Program Window - Proled Touch Control Lcd Rgb Dmx Benutzerhandbuch

CUSTOMIZE
Some parameters can be set in this menu about the appearance of the program
window.
 ZONE NAME visible – switch on and off the visibility of zone names
 DMX OUTPUT WINDOW visible – the actual RGB color on the DMX output
can be seen in every zone. This window can be switched on and off
 DMX VALUE visible – the current RGB values can be seen in every zone. The
visibility of the values can be switched on and off
 ENABLE PROGRAM PARAMETER CHANGES – By touching the ADD
PROGRAM button you can add a new program to the zones. This button
visibility can be switched on and off.
 PROGRAM BUTTON size – The button size in the program window is
variable. If one zone has only one button then there is more space in the zone
area and the button can also be bigger. If you add more buttons, space will be
smaller and the button size will be reduced automatically.
 MASTER SLIDER visible – for every zone it is possible to set a master value.
This value will reduce the RGB output color if less than 100%. This master
slider can be switched on and off.
 IMC DEVICE SELECTION IN FOOTER LINE – Device names will be visible
on program window footer page and it is possible to activate them here.
 '+' AND '-' BUTTONS FOR MANUAL SLIDERS –For precise setting of master
value possible to switch on ADD +1 and ADD -1 buttons. It will appear above
and under muster sliders
 CANCEL – the window closes without any changes in memory
 OK – the window closes and the software will save all modification
MBN GmbH

Balthasar-Schaller-Str. 3
www.proled.com
Montageanleitung / Installation manual

86316 Friedberg

Germany
34