Wall Mounting; Electrical Installation; How To Start - Proled Touch Control Lcd Rgb Dmx Benutzerhandbuch

WALL MOUNTING

 Put the TSC with display side on a table. Take care that there is no object
under the screen, because it could damage its surface!
 Remove the two screws at the lower side of the case and lift the rear part for
about 10 mm.
 Pull the rear part from the two positioning shafts at the opposite side of the
screw holes.
 Now the TSC is open and there are two separate parts: the back part and the
front part with display and electronics PCB.

ELECTRICAL INSTALLATION

 The cables coming from the wall must be passed through the center hole of
the back part.
 Mount the back part to the wall using appropriate screws.
 Connect the communication wires to the corresponding screw terminals.
 Connect the voltage supply cable to the power input terminals (the controller
now has power and will start operating)
 Put the front part on the back part by passing the positioning shafts on the
upper side through the positioning holes. Then re-tighten the the two screws
on the lower side.

HOW TO START

After starting the TSC the PROGRAM screen is displayed. The screen is divided in
two parts: the header line and the body screen.
1. First go to the setup menu to set some important parameters such as
language, display color and brightness
2. Set the controlled DMX devices in ZONE MODE – DMX PATCH menu
3. Try to control the connected DMX devices in manual mode
4. Make scenes and programs and change its parameters
5. Start programs and test it in different zones
6. Connect RMD compliant DMX devices and try the remote device management
menu
7. Connect more TSC controllers via the IMC line and try the remote control
possibility of the zones
MBN GmbH

Balthasar-Schaller-Str. 3
www.proled.com
Montageanleitung / Installation manual

86316 Friedberg

Germany
28