Disposal And Recycling; Troubleshooting - Scheppach HL850 Originalbetriebsanleitung

Extension cables must have a minimum cross-section of
1.5 mm².
When connecting to the mains or relocating the ma-
chine, check the direction of rotation (swap polarity in
the wall socket if necessary).
Turn pole inverter in the machine socket. (Fig. 14)
Connections and repairs of electrical equipment
may only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

14. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in this
packaging can be reused or recycled. The equipment
and its accessories are made of various types of mate-
rial, such as metal and plastic. Defective components
must be disposed of as special waste. Ask your dealer
or your local council.

15 Troubleshooting

In case of any malfunctions not mentioned here, contact your dealer's after-sales service.
Malfunction Possible cause
The hydraulic pump No electric power
does not start
Thermal switch of motor
cut off
The column does not Low oil level
move down
One of the levers not
connected
Dirt in the rails
Motor starts but Wrong turning direction
column does not move of 3-phase motor
down
Maintenance and repairs
All servicing jobs must be executed by specialized personnel under strict observation of the present operating instructions. Be-
fore every work, every possible caution must be taken: Switch off the motor, disconnect the power supply (pull the plug,
if necessary). Attach a board to the machine explaining the reason for being out of order: "Machine out of order due to servicing
work: Unauthorized people must not come close to the machine or switch it on."
28 GB
Dismounting and disposal
The machine does not include any components harmful
to health or environment. All the materials can be recy-
cled or decomposed the normal way.
Charge specialized personnel with the disposal that is
familiar with the possible risks and with the present man-
ual.
When the machine is not used any more and is to be
disposed of, proceed as follows:
• Cut off the electric power supply.
• Remove all electric cables and bring them to a special-
ized public collection facility following your country's
regulations.
• Empty the oil tank, fill the oil in a tight bin and bring it
to a specialized public collection facility following your
country's regulations.
• Take all other machine parts to a scrap collection facil-
ity following your country's regulations.
Be sure every machine part is disposed of following
your country's regulations.
Remedy
Check cable for electric
power
Engage thermal switch
inside the motor casing
again
Check oil level and refill
Check fixing of lever
Clean the column
Check turning direction of
motor and change
Danger class
Risk of electric shock.
This job must be done by a service
electrician.
Risk of getting dirty.
This job can be done by the
machine operator.
Risk of getting cut.
This job can be done by the
machine operator.