Settings And Ranges; For Your Safety; Error Messages; Operation - Sentiotec Ihs 1 Aufbauanleitung / Betriebsanleitung

Operating instructions for the user - Figure 5
1

Settings and ranges

1.1 What can I adjust ?
• The inside temperature, measured in degrees of
Celsius.
• The heating time in minutes.
1.2 What are my ranges of adjustment ?
• The range of adjustment of the inside temperature
for:
- infrared foil heating systems is 30 - 50 degrees
Celsius,
- infrared heating element systems is 30 - 70 de-
grees Celsius.
• You can set the heating time for 0 - 99 minutes.
2

For your safety

CAUTION - Damages of Device:
Do not pour water on the infrared control unit or clean
it with a wet cloth.
For cleaning please use a cleaning cloth, which has
been slightly moistened with a mild soapy solvent
(dish detergent).
3

Error messages

The letter E_ with a number in the display 1 indica-
tes an electrical defect of the infrared control unit (refer
to Technical Data).
The sauna control is no longer safe-to-operate:
• Pull the mains plug 8.
• Contact customer service.
• Mark the device as defective.
4

Operation

4.1 Turn on the infrared control unit
WARNING - Fire hazard:
Prior to turning on the sauna control make
sure that no combustible objects have been
placed on or in front of the IR radiant hea-
ters.
1. Plug the mains plug of the power supply 8 in a
properly grounded, ground contact outlet.
2. Turn on the infrared control unit with the ON / OFF
key 1.
The display 3 will indicate the current tempera-
ture of the inside.
4.2 How to set the inside temperature
1. Press option key SELECT 5, until the LED dis-
play TEMPERATURE 7 lights up.
The display 3 will indicate the current tempera-
ture of the inside.
NOTE:
The display flashes: The value desired is displayed.
The display does not flash: The current temperature
will be displayed.
2. Set the desired temperature with the UP / DOWN
keys 4.
The display 3 will change from the current inside
temperature to the desired temperature (display
flashes).
3. After 5 seconds the display 3 will indicate the
current inside temperature again (display 3 no
longer flashes).
Continuation on page 16.
15