Operation In Fm-Mode - Renkforce NE-6210 Bedienungsanleitung

Calling information
• Push the MENU/INFO button (5) to call various information.
• The following information is displayed:
Information on title/artist etc. > Signal strength > Programme type > Ensemble name
> Frequency > Signal error rate > Data bit rate > Information for power supply > Time
> Date
Deleting inactive stations
Stations that are no longer broadcasting can be deleted from the station list.
• In the DAB menu, select the item "Prune" and push the SELECT (8) button.
• Select "Yes" and push the SELECT (8) button again.
• All stations that cannot be received are deleted from the station list.
d) Operation in FM-Mode
Manual station search
• Briefly push the (4) or
• Every push of a button changes the reception frequency in steps of 50 kHz.
Automatic station search run
• Push the (4) or
ning...).
• If a FM station with sufficiently strong signal is found, the scan stops and the station
is played back.
Please set weaker stations by manual station selection.
Use the menu "Scan setting" to set if the automatic station scan is to find only
strong stations ("Strong stations only") or all stations ("All stations"). The set-
ting "All stations" may lead to the station scan stopping after every frequen-
cy stop in some broadcasting areas. In this case, set the search setting to
"Strong stations only".
(6) button to change the reception frequency step by step.
(6) button and keep it pushed until the station scan starts (Scan-
35