Function Key - Sony Rm-Pj1001 Bedienungsanleitung

Location and Function of Controls
6 CENT R/B keys*
Enter the centering adjustment mode of the red and blue.
R: Press to enter the red centering adjustment mode.
B: Press to enter the blue centering adjustment mode.
Perform the centering adjustment using the four arrow keys.
7 MEMORY key*
Stores various settings and adjusted data into memory.
8 ON/STANDBY keys*
Press the ON key to turn the projector on when the projector
is in standby mode. To turn it off, press the STANDBY key.
9 MENU key*
Press to display the menus. Press it again to turn off the
menu.
!º Arrow keys
Adjust the picture on the screen, and in the menus adjust the
values or select items.
!¡ ENTER key
Stores the settings in the menu.
The key is also used to designate and to display the index
number.
!™ FUNCTION key*
If the projector has extended functions, press the key to use
them.
20
!£ POSITION +/– keys*
Selects the position to be adjusted on the screen in the
blanking adjustment mode.
These keys also adjust the position of the RGB signals on the
screen.
!¢ VOL (volume) +/– keys*
Adjust the volume.
!∞ PICTURE CONTROL +/– keys*
Adjust the picture conditions: CONTR (contrast), BRIGHT
(brightness), COLOR, HUE and SHARP (sharpness).
!§ RESET key*
Resets the adjusted levels to the initial setting levels, etc.
!¶ BLKG (blanking) adjustment key*
Enters the blanking adjustment mode.
Next, press POSITION +/– key !£ to select the position to be
adjusted on the screen, and then adjust the position using the
arrow keys.
!• SWITCHER/VIDEO MEMORY/INDEX select
switch*
Selects the function of the SWITCHER/VIDEO MEMORY/
INDEX keys.
Set to SWITCHER to select the input from the PC-3000 or
the PC-1271 series signal interface switcher.
Set to VIDEO MEMORY to select settings or adjusted data.
Set to INDEX to select a projector by its index number when
multiple projectors are used.