Sony RM-PJ1001 Bedienungsanleitung Seite 21

!ª SWITCHER/VIDEO MEMORY/INDEX keys*
When the SWITCHER/VIDEO MEMORY/INDEX
select switch is set to SWITCHER
When the PC-3000 or the PC-1271 series switcher is
connected to the projector, press a number key (1 to 8) to
select the input from the switcher. Number key 9 and the
10/0 (ALL) key do not function.
To select an input when multiple switchers are connected,
set the SWITCHER/VIDEO MEMORY/INDEX select
switch to SWITCHER, then press the SW NO/OFF/GROUP
key. Next press the switcher number (1 to 8) and the input
number (1 to 8) in sequence. Be sure to press the keys one
after another within 2 seconds.
e.g. To select input 4 of switcher 2, press the keys as follows:
SW NO n 2 n 4.
When the SWITCHER/VIDEO MEMORY/INDEX
select switch is set to VIDEO MEMORY
Select the number of the VIDEO MEMORY when the
projector has a VIDEO MEMORY function. To select the
data set and adjusted in INPUT MEMORY, press the SW
NO/OFF/GROUP key to set VIDEO MEMORY to OFF.
Note
The 10/0 (ALL) key can be used as "10" key only when the
select switch is set to VIDEO MEMORY.
When the SWITCHER/VIDEO MEMORY/INDEX
select switch is set to INDEX
When multiple projectors are connected, select the projector
to be adjusted by the index number set on each projector or
the IFB-101 interface board installed on each projector.
Press the index number (1 to 99) and press the ENTER key.
Be sure to press the keys one after another within 2 seconds.
e.g. To select 1, press the keys as follows:
0 n 1 n ENTER, or 1 n ENTER.
To select 12, press the keys as follows:
1 n 2 n ENTER.
When adjusting all the projectors simultaneously, press the
10/0 (ALL) key and ENTER key.
Note
Depending on the projector, pressing "0", "0" and
"ENTER" is not effective.
To select the projector to be adjusted when the
projectors are divided into multiple groups
First select the group number and then the projector's index
number.
To select a group, press the SW NO/OFF/GROUP key, the
group number (1 to 99) and the ENTER key in sequence.
When the group has a double-digit number, be sure to press
the SW NO/OFF/GROUP key before pressing each number
key.
Then press the index number of the projector (1 to 99) and
finally press the ENTER key.
e.g. To select the index number 52 projector in group 91,
press the keys as follows:
GROUP n 9 n GROUP n 1 n ENTER n 5 n 2
n ENTER.
21