Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 36
The effective keys for each projector model are limited to
the functions of the projector.
The keys and switches marked with * may not function
depending on the projector or the type of the input signal.

1 LIGHT button

Illuminates the key indicators when the COMMAND switch
5 is set to ON. If the switch is set to OFF, only the
COMMAND switch is illuminated.
If you do not press any key on the Commander for more
than 30 seconds, the key indicators turn off automatically.
The indicators also turn off if you press the LIGHT button
again.
2 Transmission indicator
The light goes on each time a key is pressed. If the indicator
does not light when the Commander is used wirelessly,
replace the batteries.
3 STATUS ON/OFF keys
Press OFF to eliminate the on-screen display.
Press ON to restore the on-screen display.
Note
The menus (PAGE) and warning messages appear even if
the OFF key is pressed.
4 RGB keys*
Adjust the picture.
APA: Press to adjust the position of the picture on the
screen automatically so that the picture is clearly visible
when the signals are input from a computer.
DOT PHASE: Press to adjust the phase of the input signals
from LCD panels and INPUT A/B/C connectors (except
for 15K/ video/ HDTV signals). After pressing the DOT
PHASE key, adjust the position of the picture using the
four arrow keys.
SIZE: Enters the size adjustment mode for the input signal.
Next adjust the size of the picture using the four arrow
keys.
B to reduce horizontal size
b to expand horizontal size
V to expand vertical size
v to reduce vertical size
Press the MEMORY key 7 to store the adjusted value.
SHIFT: Enters the shift adjustment mode for the input
signal. Next adjust the position of the picture using the
four arrow keys. The picture shifts in the direction of
the arrow on the pressed key.
Press the MEMORY key 7 to store the adjusted value.
5 COMMAND ON/OFF switch
No keys except for the LIGHT button on the Remote
Commander function when this switch is set to OFF.
This saves battery power, preventing the keys from being
accidentally pressed when not in use or when being carried
in a bag, etc.
19
Inhaltsverzeichnis
loading

Inhaltsverzeichnis