Safety; Safety Instructions - Lenord, Bauer GEL 3011 Betriebsanleitung

2 Safety

2 Safety
2.1

Safety instructions

Do not drill holes in housing.
Do not bang or drop device.
Do not hit or stand on the housing.
Only undo or make connections if electrically isolated. Ensure the sup-
ply voltage is free of interference due to contact bounce.
The tower oscillation monitor must always be disconnected from the
supply of electrical power during installation and wiring.
Only touch connector pins and wires if you are suitably
earthed (see EN 100015-1).
To improve the electromagnetic environment
● Use metallised connectors
● Connect screen to the connector
EMV/EMC
● Keep unscreened wires as short as possible
● Make short earth connections with a large cross-section
● Physically separate signal wires from power cables
● Lay equipotential bonding cables, if currents flow along the
screens
It is imperative you comply with the technical data and the information on the connection
conditions on the rating plate and in the related documentation.
28
Safety instructions
Lenord + Bauer
GEL 3011