Auto Setup For Appropriate Surround Effects (Intellibeam); Installing The Intellibeam Microphone - Yamaha YRS-2100 Bedienungsanleitung

Auto setup for appropriate
surround effects (IntelliBeam)
This unit creates a sound field by reflecting sound beams on the
walls of your listening room and by broadening the cohesion of
all the channels. Just as you would arrange the speaker position of
other audio systems, you need to set the beam angle to enjoy the
best possible sound from this unit.
This unit employs the beam optimization and sound optimization
features with the aid of the supplied IntelliBeam microphone, allowing
you to avoid troublesome listening-based setup and achieving highly
accurate sound adjustments that best match your listening
environment. We call these two features "IntelliBeam" generically.
Beam optimization:
This feature optimizes the beam angle so that the parameter best
matches your listening environment.
Sound optimization:
This feature optimizes the beam delay, volume, and quality so
that the parameters best match your listening environment.
This unit performs these two automatic optimizations with the aid
of the supplied IntelliBeam microphone.
Note
• The AUTO SETUP procedure may not be run successfully if this
unit is installed in one of the rooms described in "Installing this
unit" on page 6. In such cases, run MANUAL SETUP (☞p. 14) to
manually adjust the corresponding parameters.
• Do not connect the IntelliBeam microphone to an extension cable
as doing so may result in an inaccurate sound optimization.
• After you have completed the AUTO SETUP procedure, be sure
to disconnect the IntelliBeam microphone.
• The IntelliBeam microphone is sensitive to heat.
– Keep the IntelliBeam microphone away from direct sunlight.
– Do not place the IntelliBeam microphone on top of this unit.

Installing the IntelliBeam microphone

Follow the procedure below to connect the IntelliBeam
microphone to this unit and place it in a proper location.
1
Place the IntelliBeam microphone on a flat
level surface at your normal listening position.
Use the supplied cardboard microphone stand or a tripod
to place the IntelliBeam microphone at the same height as
your ears would be when you are seated.
■ Assembling the supplied cardboard
microphone stand
1 2
Remove
Fit in
Place
horizontally
4 5
Run
through
y
2)
• "BEAM+SOUND OPTIMIZE" screen appears automatically when
the IntelliBeam microphone is connected. "BEAM OPTIMIZE
ONLY" or "SOUND OPTIMIZE ONLY" can be selected separately
in setup menu (☞p. 14).
2)
3 Fit in
Make sure that there are no obstacles between the
IntelliBeam microphone and the walls in your listening
room as these objects obstruct the path of sound beams.
However, any objects that are in contact with the walls
will be regarded as a protruding part of the walls.
IntelliBeam microphone
Center height of this
unit
Cardboard microphone
stand
1.8 m (6.0 ft)
or more
Center line
Cardboard microphone stand
2
Check if a supplied video pin cable is
connected and headphones are not
connected.
• Data set automatically can be saved in the system memory (☞p. 16).
You can save the several data depending on listening room and you
can change the setting conveniently.
Initial settings
Upper limit
Within 1 m (3.3 ft)
Within 1 m (3.3 ft)
Listening
position
Lower limit
IntelliBeam
microphone
11
En