Connection/Initial Settings; Installation; Before Installing This Unit - Yamaha YRS-2100 Bedienungsanleitung

Installation

Place the unit in the appropriate position after assembly. Refer to the supplied Install Manual for assembly. This section describes a
suitable installation location to install this unit. Refer to "Notes on installation" below and place the unit correctly in the safe place.
Notes on installation
• Install your TV in accordance with the manufacturer's instructions to prevent it from toppling over.
• This unit's speakers use magnets. Do not place items that are sensitive to magnetism, such as clocks, credit cards, floppy disks, etc., on top of the
rack.
• When the unit is positioned close to a CRT-type TV, picture or sound distortion may occur.
Caution: Handling the tempered glass
The top glass panel is constructed of glass that has been tempered for strength and safety. In addition, a safety film has been applied to the tempered
glass to offer additional protection against injuries that may be caused by shattering glass. However, if you handle the glass inappropriately, the glass
might break and glass fragments might fly, causing injuries. Be sure to follow the precautions listed below:
• Do not allow any strong impacts to the glass (for example, do not allow thrown objects to strike the glass).
• Do not allow sharp objects to contact the glass.
• If the tempered glass has been scratched, it might break unexpectedly. If you see scratches, replace the glass immediately.
• Do not remove the glass caution sticker.
• Install this unit in the center of the left and right walls.
• Listening position (such as sofa, etc.) should be located at the
front of the unit.
• The distance between listening position and the unit should be
more than 1.8 m (6 ft).

Before installing this unit

This unit creates surround sound by reflecting projected sound beams off the walls of your listening room. The surround sound effects
produced by this unit may not be sufficient when this unit is installed in the following locations.
• Rooms with walls inadequate for reflecting sound beams
• Rooms with acoustically absorbent walls
• Rooms with measurements outside the following range: W (3 to 7 m (10 to 23 ft)) × H (2 to 3.5 m (7 to 11.5 ft)) × D (3 to 7 m (10 to
23 ft))
• Rooms with less than 1.8 m (6 ft) from the listening position to this unit
• Rooms where objects such as furniture are likely to obstruct the path of sound beams
• Rooms where the listening position is close to the walls
• Rooms where the listening position is not in front of this unit
■ My Surround
In the room such as above, you can enjoy rich surround effects by My Surround (☞p. 24).
YRS-2100
YRS-2100
Maximum load
YRS-1100
10kg each
(Left, center
and right)

CONNECTION/INITIAL SETTINGS

80kg
40kg
Interior slide sheet
An interior slide sheet is attached to the
bottom of the unit, allowing you to
move the unit into position easily. To
prevent damage to the floor, clean the
floor of dust and rubbish before moving
the unit.
YRS-1100
Maximum
load
50kg
15kg
30kg
5
En