Yamaha YRS-2100 Bedienungsanleitung Seite 17

■ Error messages for AUTO SETUP
If an error message is displayed on your TV, check the error
message list to solve the problem and then follow the procedure
below.
[ERROR E-1]: Press ENTER key to run the AUTO SETUP
procedure again. Or press
measurement.
[ERROR E-7]: Press key to turn this unit to standby
mode, then run AUTO SETUP procedure again after turning this
unit on.
Other errors: Press RETURN key to cancel the operation
and then run the AUTO SETUP procedure again.
If the problem is difficult to be solved, configure the settings
manually in "SETUP MENU" (☞p. 32).
ERROR E-1: Please test in quieter environment.
Cause
There is too much unwanted
noise in your listening room.
ERROR E-2: No MIC detected. Please check MIC
connection and re-try.
Cause
The IntelliBeam microphone is
not connected to this unit or
disconnected during the AUTO
SETUP procedure.
ERROR E-3: Unexpected control is detected. Please
re-try.
Cause
Some other operations were
performed on this unit while the
AUTO SETUP procedure was in
progress.
ERROR E-4: Please check MIC position. MIC should
be set in front of the Sound Projector and re-try.
Cause
The IntelliBeam microphone is
not placed in front of this unit.
ERROR E-5: Please check MIC position. MIC should
be set above 1.8m/6.0ft and re-try.
Cause
The IntelliBeam microphone is
not placed in the right distance
from this unit.
key to continue the
Remedy
Make sure that your listening
room is as quiet as possible. You
may want to choose certain hours
during the day when there is not
much noise coming from outside.
Remedy
Connect the IntelliBeam
microphone to this unit firmly.
Remedy
Do not perform any other
operations while the AUTO
SETUP procedure is in progress.
Remedy
Make sure that the IntelliBeam
microphone is installed in front
of this unit.
Remedy
Make sure that the IntelliBeam
microphone is installed more
than 1.8 m (6.0 ft) from the front
of this unit and within 1 m (3.3
ft) from the center height of this
unit.
ERROR E-6: Volume level is lower than expected.
Please check MIC position/connection and re-try.
Cause
The IntelliBeam microphone
cannot collect the sound
produced by this unit because the
sound output level is too low.
ERROR E-7: Unexpected error happened. Please
turn off and re-try.
Cause
An internal system error
occurred.
ERROR E-8: Headphones are connected. Please
unplug the headphones and re-try.
Cause
A headphone is connected.
Initial settings
Remedy
Make sure that the IntelliBeam
microphone is firmly connected
to this unit and placed in a proper
location. If the problem persists,
contact the nearest
authorized Yamaha service
center for assistance.
Remedy
Press key to turn this unit
to standby mode, then run AUTO
SETUP procedure again after
turning this unit on.
Remedy
Disconnect the headphone and
re-try.
15
En