Using Auto Setup (Intellibeam) - Yamaha YRS-2100 Bedienungsanleitung

Initial settings
y
1)
When pressing RETURN key displays the setup menu
Press SETUP key repeatedly and display the menu screen again, then
select: "AUTO SETUP" "BEAM+SOUND OPTIMIZE".
When the screen is not displayed
Confirm the case below.
– The input jack of your TV and the video output jack of the unit are
connected.
– The input of your TV is set to "VIDEO INPUT 1 (example)".
12
En

Using AUTO SETUP (IntelliBeam)

Note
• It is normal for loud test tones to be output during the AUTO
SETUP procedure. Make sure that there are no children around
in the listening room while the AUTO SETUP procedure is in
progress.
• Make sure that your listening room is as quiet as possible. For
accurate measurement, turn off air conditioner or other devices
that make noises.
• If there are curtains in your listening room, we recommend
following the procedure below.
1 Open the curtains to improve sound reflection.
2 Run "BEAM OPTIMIZE ONLY".
3 Close the curtains.
4 Run "SOUND OPTIMIZE ONLY".
1
Turn the unit and your TV on.
2
Switch TV's input to "VIDEO INPUT 1
(example)".
3
Connect the supplied IntelliBeam
microphone to the INTELLIBEAM MIC jack.
The jack is on the underside of the main unit.
y
2)
"BEAM+SOUND OPTIMIZE" is selected automatically. When you
perform "BEAM OPTIMIZE ONLY" or "SOUND OPTIMIZE ONLY"
only, refer to "AUTO SETUP via setup menu (☞p. 14)".
y
3)
• Wait outside the room during the AUTO SETUP procedure.
• The AUTO SETUP procedure takes about 3 minutes.
• To cancel the AUTO SETUP procedure after it is started, press
RETURN key.
IntelliBeam microphone