Manual Setup-Mode, Deletion And Manual Setting Of The End Positions - Selve Sez-Rc Originalbetriebsanleitung

iveo initial operation/setting by radio

6.1.3. Manual setup-mode, deletion and manual setting of the end positions

in operation bottom position, top stop/release
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored. Drive against the top stop until the motor is auto-
matically switched off.
Caution! Only connect the radio motor that you wish to program to the mains. It is not possi-
ble to program more than one motor at the same time.
Setting with trans-
mitter
6 s
or
3 s
or
Auto-Stop
1 s
Drive
Connect to power.
Press the UP and DOWN buttons at the transmitter at
the same time. The transmitter is temporarily pro-
grammed into the motor.
Press the STOP button of the transmitter for 6 seconds.
Move the motor to the lower end position with the UP
or DOWN button.
STOP
Press the STOP button of the transmitter for 3 seconds.
The correct rotation direction assignment will be car-
ried out at the end of the end position setting.
Run against the limit stop at the top without stopping;
the motor stops automatically.
STOP
The end positions are now set and the rotation direc-
tion assignment is correct. Perform a test run.
Press the PROG button at the transmitter. The transmit-
ter is now permanently programmed.
59
EN