Manual Setup-Mode, Deletion And Manual Setting Of The End Positions - Selve Sez-Rc Originalbetriebsanleitung

Setting of the end positions

4.5.2. Manual setup-mode, deletion and manual setting of the end positions

in operation bottom position, top position
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored.
Setting with
Drive
setting switch
E
6 s
E
STOP
E
3 s
E
STOP
3 s
E
3 s
Press the E button of the setting switch for 6 seconds. The
motor will switch to manual setting mode. Both limit positions
already set will be deleted.
Move the motor exactly to the lower end position with the UP
or DOWN button.
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out at
the end of the end position setting.
Run exactly against the limit stop at the top and press the
E button at least 3 seconds.
Press the E button for 3 seconds. The end positions are now set
and the rotation direction assignment is correct. Perform a test
run.
47
EN