HOMCOM BL-K17-D Bedienungsanleitung Seite 5

EN
operation chart
Function Introduction
1. Plug in the power, turn on the power switch, the display screen shows the ambient
temperature, the product standby.
2. ON/OFF button: press "
the air supply indicator will light up. Press "
Directly to turn it off. In the reheating state, Press "
supply air for 30 seconds after shutdown.
3. Heating: After pressing the "ON/OFF" once, press the "
the indicator light will show "
indicator light show "
function off.
Temp： Press "
you first press the temperature button, the display shows the temperature indicator
light, and the default temperature in the display is 25℃. Then press the
temperature button again, the display will show 26-27-28---40-15-16-17-18----℃.
After pressing the temperature button, if you don't press the button when the
temperature number flashes for 3 seconds, the final temperature in the display is
your set temperature. After setting the temperature, the temperature indicator
light is steady on in the display, and the display shows the ambient temperature.
After pressing the temperature button, if you press "+" or "-" within 3 seconds, the
display will shows "26-27-28-29-----" or "24-23-22-21-----". If don't press the button
within 3 seconds, the final temperature in the display is your set temperature. In
any working condition, it is invalid only pressing "+" or "-" .Under the working
environment of temperature setting, press the"
setting, the product stops heating, and there is only air supply function. If the set
temperature is 2℃ or 3℃ higher than the ambient temperature, Product is low
heating "
Product is high heating "
higher than the ambient temperature or the same as or lower than the ambient
temperature, the product will immediately only work by air supply.
" for the first time, the product will be powered on and
", now is Low Heating. Press "
", now is High Heating. Press "
", For the temperature button: in any working condition, when
". If the set temperature is 4℃ higher than the ambient temperature,
". If the displayed setting temperature is only 1℃
" again in the unheated state.
",product will continue to
" to cancel the temperature
4
" for the first time, and
" twice and the
" third time, Heating