Fitting The Auxiliary Handle; Checking The Battery Charge Level; Charging The Battery; Operation - Parkside Psbsa 20-Li C3 Originalbetriebsanleitung

IE NI
• Directional data viewed from behind.
Attaching the attachment tool (Fig. B)
1. Open drill chuck: Turn the keyless chuck
(2) ⭮ .
2. Push the attachment tool as far as pos-
sible into the drill chuck opening (1).
3. Clamp attachment tool: Turn the keyless
chuck (2) ⭯ .
Removing the attachment tool (Fig. B)
1. Open drill chuck: Turn the keyless chuck
(2) ⭮ .
2. CAUTION! Risk of burn injury! Attach-
ment tools – especially drills – can be-
come very hot. Wear protective gloves
whenever appropriate.
Remove the attachment tool.

Fitting the auxiliary handle

Procedure (Fig. C)
1. Screw the auxiliary handle (13) on the
right or left into the holder for the auxili-
ary handle (11) on the device head.
2. Tighten the auxiliary handle (13) hand-
tight.

Checking the battery charge level

LEDs
red, orange, green
red, orange
red
1. Press the button (16) next to the charge
level indicator button (17) on the battery
(15).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (15) when only the red
LED on the charge level indicator (17) is
illuminated.

Charging the battery

See also the charger instruction manual.
Notes
• If warm, allow the battery to cool before
charging.
• Do not expose the battery to direct sun-
light for long periods and do not place it
on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (15) from the device.
10
Meaning
Battery charged
Battery partially
charged
Battery needs to be
charged
2. Push the battery (15) into the charging
slot of the battery charger (14).
3. Connect the battery charger (14) to a
power outlet.
4. After charging, disconnect the battery
charger (14) from the mains.
5. Pull the battery (15) out of the battery
charger (14).
Control LEDs on the charger (14):
green red
lights up —
— lights up
— flashes
flashes flashes

Operation

Inserting and removing the
battery
WARNING! Risk of injury due to uninten-
tional start-up. Only insert the battery into
the device once the device is fully prepared
for use.
NOTICE! Risk of damage! An incorrect bat-
tery can damage the device and battery.
Inserting the battery
1. Push the battery (15) along the guide into
the battery holder (8).
You will hear the battery click into place.
Removing the battery
1. Press and hold the battery release (18) on
the battery (15).
2. Pull the battery out of the battery holder
(8).

Switching on and off

Switching on
1. Select the direction of rotation with the
rotation direction switch (6).
2. Select a gear with the gear selector
switch (4).
3. Use the torque adjustment ring (3) to se-
lect a maximum torque or drilling ( )/im-
pact drilling ( ).
4. Press and hold the On/off switch (10).
The LED work light (9) lights up.
Meaning
• Battery is fully
charged
• stand-by (No bat-
tery inserted)
Battery is charging
Battery is overheated
Battery is defective